Low Headroom Type Single Girder Workshop Overhead Crane 10 Tone

Low Headroom Type Single Girder Workshop Overhead Crane 10 Ton

Low Headroom Type Single Girder Workshop Overhead Crane Description:

LDC electric single-girder bridge crane is composed of box-shaped main girder, end beam, electric hoist and traveling mechanism welded by steel plates. The lower flange of the main beam (material 16Mn) is the running track for the electric hoist to complete the cargo transportation.

The electric hoist with low headroom structure can effectively increase the lifting height, and is suitable for places with low factory buildings and high requirements for lifting height.

LDC single-girder bridge cranes are suitable for occasions where the factory building is limited and the lifting height of ordinary cranes cannot meet the needs of customers. Used together with low headroom hoists, it is suitable for places where the height from the track surface of the factory building and warehouse to the bottom chord of the roof truss does not exceed 500mm.

Low Headroom Type Single Girder Workshop Overhead Crane Parameters Table:

Low Headroom Type Single Girder Workshop Overhead Crane Advantage:

• The main beam is a box structure, good manufacturing technology, small welding deformation, small residual stress
• The fillet welds are welded by automatic CO2 gas shielded welding, with high quality and beautiful appearance
• The improved design of the main end beam, diversified connection, effectively increase the lifting height, overcome the phenomenon of three legs, long service life of the wheel, smooth operation
• Optimized and improved electric wire rope hoist, the wheels run smoothly, the whole machine low noise, strong overload capacity, the working level of the mechanism is high, the force state is good, not slip
• Main contactor using Schneider electrical components, high reliability, long service life;
• Electric hoist power supply using C-type rail suspension cable, novel structure, beautiful appearance, safe and reliable long life
• Independent mobile ground operating flashlight door or remote control device, safe and convenient operation
• Overhead traveling on the steel structure, normally in workshop
• Light self weight, could save steel structure cost.
• Lifting and traveling is very accurate.
• VVF/ frequency inverter control, continuous speeds to operate, very stable to lift and traveling.
• Six direction action, to make sure the enough wide working area.

Low Headroom Type Single Girder Workshop Overhead Crane Details: